How to press DTF with a home iron

No press? A household iron works for smaller designs. Hold it still, press firmly and give every section enough time.

  • Beginner
  • 5 min read
  • 6 steps
Setting
Cotton, no steam
Time
20 sec per section
Pressure
Firm, held still
Peel
Hot

Times are for cotton. Blends and polyester need less heat and less time, so check the chart below.

Step 1

Heat the iron

Set the iron to cotton, no steam. Empty the water tank so no steam escapes, then let the iron heat fully.

Step 2

Use a hard surface

Lay a thin towel or pillowcase on a sturdy table or countertop. Ironing boards flex too much for an even bond.

Step 3

Prep and position

Press the garment for a few seconds to remove moisture. Place the transfer design-up, adhesive side down, with the top of the design 4–5″ below the collar. Cover it with parchment or kraft paper.

Placement

Where to place it

Use the same rule on the front and the back: the top of the design starts 4–5″ below the collar.

Front4–5″ below the collar

Back4–5″ below the collar

Measure from the round bottom edge of the collar, not the shoulder seam. On the back, feel for that round edge from the back of the shirt and measure down from there, so the design sits fully below it.

Step 4

Press section by section

Press straight down with firm pressure and hold the iron still. On cotton, hold each section for about 20 seconds, then lift, move and repeat until you've covered the whole design, edges included.

Fabric guide

Iron settings by fabric

Most irons don't show degrees. Use the cotton setting for cotton and turn the dial down for blends and polyester.

Iron settings by fabric
Fabric Temperature Time Pressure
CottonCotton setting 325°F163°C 20 sec per section Firm
50/50 cotton-poly 300°F149°C 15 sec per section Firm
Tri-blend 275°F135°C 15 sec per section Firm
Polyester 275°F135°C 10 sec per section Firm

Nylon or silk? These need lower, steadier heat than most irons hold. A heat press or EasyPress with a set temperature is safer, and either way, test on a scrap first.

Step 5

Peel while it's hot

Peel the film right away, while it's still hot. Use one smooth, steady motion and keep the film low and close to the fabric.

Step 6

Finish with a second press

Cover the design with parchment paper, kraft paper or a Teflon sheet and press again for 15 seconds, section by section.

Ready for your next press?

Build a gang sheet or order transfers by size. No minimums.

Start an order