How to press DTF with a Cricut EasyPress

An EasyPress is great for small batches and single shirts. The secret is a firm surface and firm, even pressure.

  • Beginner
  • 5 min read
  • 6 steps
Temperature
300°F
Time
10–15 sec
Pressure
Firm, even
Peel
Hot

For cotton and cotton blends. Pressing polyester or nylon? Drop to about 275°F for around 7 seconds.

Step 1

Set up on a firm surface

Work on an EasyPress mat or a firm, heat-safe surface. Ironing boards have too much give for even pressure.

Step 2

Heat up and prep

Set the EasyPress to 300°F for cotton and cotton blends, or about 275°F for polyester and nylon. Once it's hot, press the garment for 5 seconds to remove moisture and wrinkles.

Step 3

Position the transfer

Lay the transfer design-up, adhesive side down. The top of the design sits 4–5″ below the collar, front or back. Cover it with parchment paper or a Teflon sheet.

Placement

Where to place it

Use the same rule on the front and the back: the top of the design starts 4–5″ below the collar.

Front4–5″ below the collar

Back4–5″ below the collar

Measure from the round bottom edge of the collar, not the shoulder seam. On the back, feel for that round edge from the back of the shirt and measure down from there, so the design sits fully below it.

Step 4

Press firmly

Press straight down with both hands for 10–15 seconds, or around 7 seconds on polyester or nylon. Keep the pressure firm, even, and don't move the press.

Design wider than the plate? Press it in sections and overlap each one slightly so nothing gets missed.

Fabric guide

Settings by fabric

Synthetic fabrics scorch and shine faster than cotton, so they need less heat and a shorter press.

Settings by fabric
Fabric Temperature Time Pressure
Cotton & cotton blends 300–320°F149–160°C 10–15 sec Medium-firm
Polyester & poly blendsStart at 275°F 270–290°F132–143°C 7–10 sec Medium
NylonStart at 275°F 260–280°F127–138°C 7–10 sec Light-medium
Silk 250–265°F121–129°C Test first Light

Polyester: too much heat can leave press marks or make the fabric's dye bleed into the print. Stay in the lower range.

Nylon: may need a nylon-compatible adhesive, especially if it has a water-resistant coating, like rain jackets and bags. Message us before ordering for coated nylon.

Silk: use light pressure and test on scrap fabric first.

These are starting points, not universal recipes. Settings vary by press and garment, so press a test piece first.

Step 5

Peel while it's hot

Peel the film right away, while it's still hot. Use one smooth, steady motion and keep the film low and close to the fabric.

Step 6

Finish with a second press

Cover the design with parchment paper or a Teflon sheet and press again for 7–10 seconds at the same temperature. It locks the print in and leaves a soft, matte finish.

Ready for your next press?

Build a gang sheet or order transfers by size. No minimums.

Start an order